Saiweb

Part 2 has finally arrived …. don’t all cheer at once now …

In part two I will cover how to run an IP range scan using bash script, and if the host can be pinged retrieve the MAC address of the connected host.

Now bare in mind this script was written to run from a MAC running OSX Leopard.


#!/bin/bash
#colours
function colours {
CLEAR='\e[00m';
GREEN='\e[0;32m';
RED='\e[0;31m';
YELLOW='\e[1;33m';
}
#ipscan
function ipscan {
IPS_START=1;
IPS_END=254;
IPS_RANGE=192.168.1.
echo "Now running IPSCAN $IPS_RANGE$IPS_START - $IPS_RANGE$IPS_END"
for ((i=$IPS_START;i<=$IPS_END;i+=1)); do
RESULT=`ping -c 1 -t 1 $IPS_RANGE$i | grep "bytes from"`;
if [ -z "$RESULT" ]; then
echo -e “$IPS_RANGE$i:$RED DEAD $CLEAR”;
# If you comment out the above to report just the alive hosts, bash gets a bit funny about not processing anything here, so uncomment the below to keep it happy
#holder=$i;
else
MAC=`arp $IPS_RANGE$i | awk ‘{ print $4 }’;`;
echo -e “$IPS_RANGE$i:$GREEN ALIVE $CLEAR ($MAC)”;
fi
done
}
colours;
$1 $2


To make this work on your Linux distro replace -t in the ping command with -W and check the awk entry for the arp output, a display of (no) means that no ARP entries could be found for the host, and change the IP range to that of your network.

That’s it for this part, dump this is a file and chmod +x as useual and run with ./script.sh ipscan.

This entry was posted on Tuesday, October 14th, 2008 at 8:40 am and is filed under Bash Script, Linux, Mac. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.